(RD28) Shredder aka RD28 build continues

Published: Sat Apr 14 2012

---

To begin with, I have bought 10 micro motors, the same ones used on rd22 and rd23,

however once I had assembled all 6 motors,  I realized they would not fit the frame, becuase this version of the fram is actually larger than the original Shrediquette Bolt!!!

So back to the drawing board, and I decided to use Suppo 1000kv motors,

not sure if they will even work for this, but decided to try anyway, and what do you know, they are too tall so I modified the frame design, ok, we are barely started and I have already altered the design <ikes!> here you see the motors mounted to each other, in a very different way than intended but it might get the job done.

here you can see all 6 motors assembled and ready to go into the frame, which I still have to build but is radically simple to build.

this is the top assembled with a single motor set attached

this is the bottom

Frame is now fully assembled, ready for ESCs, FC etc.

And thats it for one night!