Growing (Best Practices) 2021

Published: Mon May 03 2021

soak rockwool plugs in water (5.5 PH is optimal)
Have empty cup of water (5.5 PH is optimal) for cut stems
Larger leaves mean faster rooting, take a top, or a near bottom branch
Cut 1 - There should be a couple of nodes below the top of your chosen cutting leave extra, you will make cut 2 at the node.
Place immediately into water
Cut 2 - Cut at 45 degrees
Scrape - Irritate the stem above the cut with a knife
Back to the water, rinse and wet again.
Add rooting powder
Set into semi-open rockwool plug, close then
Push clone down into plug
set plug into a spot in the cloning tray
ensure water levels are good
fully close and add light - 24h
check on day 1
day 3 open for a minute
day 4 open for 10 mins and leave vents at 25%
Day 5 Open for 15 minutes and leave vents at 50%
Day 6

Clones prefer temperatures between 75°F(24°C) and 85°F(26°C), with the ideal temperature around 78°F.(26°C)